Tracker 4WD L4-1.6L VIN 6 (1998)
1. Route the O/D switch wire harness through the select lever tube in order to ensure that the O/D switch wire harness tube is in the correct position.
2. Ensure that the detent release guide taper is toward the rear of the vehicle.
3. Position the knob assembly (1) over the selector lever tube.
4. Secure the knob assembly with the two screws.
5. Install the new O/D switch wire coupler.
6. Install the O/D switch wire harness to the O/D switch wire clamp.
7. Install the console. Refer to Instrument Panel, Gages and Warning Indicators.