Tracker 4WD L4-1.6L VIN 6 (1998)
^
The transfer plate
^
The transfer plate gaskets
^
One check ball
NOTICE: When lowering the control valve body assembly, disconnect the manual valve link from the parking lock and range selector lever. Use
caution to avoid losing the check ball in the transmission case passage. When the valve body is removed, the check ball should drop out of the case
passage onto the top of the valve body.
Control Valve Body Assembly Installation
INSTALLATION
^
Tools Required
-
J 3387-2 Converter Housing Guide Pin
-
J 36850 Transjel (R) Transmission Assembly Lubricant
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Install the following items into the transmission case:
^
The check ball
^
The transfer plate gaskets
^
The transfer plate
^
The valve body
^
The manual detent roller
NOTICE: Be sure to install the check ball in the transmission case passage when installing the valve body. Use a small amount of J 36850
Transjel (R) transmission assembly lubricant, or an equivalent, to keep the check ball in place during valve body installation. Failure to install the
check ball correctly may result in transmission damage or transmission shift failure.
3. Using the J 3387-2 to align the valve body with the transmission case, install the valve body (1) onto the transmission case with nine bolts.
^
Tighten the 9 valve body bolts to 19 Nm (14 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
