Tracker 4WD L4-1.6L VIN 6 (1998)
16. Measure the clutch disc (1) for runout using the J7872. Place the disc (1) between two horizontal arbors and turn slowly while measuring runout. If
clutch disc runout exceeds 0.8 mm (0.031 inch), replace the clutch disc (1).
INSTALLATION PROCEDURE
^
Tools Required
-
J 37761 Clutch Alignment Arbor
-
J 35271 Flywheel Holder
1. Install the flywheel to the crankshaft aligning index marks made during removal; secure the flywheel with six flywheel bolts.
^
Tighten the flywheel bolts to 78 Nm (56 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the J 35271 to the engine block in order to hold the flywheel stationary.
3. Install the clutch disc to the flywheel using the J 37761 to center the disc on the flywheel and support the disc in place.
