Tracker 4WD L4-1.6L VIN 6 (1998)
Differential Case: Service and Repair
Differential Case Assembly Disassemble
REMOVAL PROCEDURE
^
Tools Required
-
J 3289-20 Holding Fixture Base
-
J 3289-21 Holding Fixture
-
J 37769 Differential Holding Fixture Adapters
-
J 8614-01 Pinion Bearing Installer
-
J 22912-01 Rear Bearing Remover
-
J 22888-D Side Bearing Remover
-
J 8107-4 Differential side Bearing Remover Plug
-
J 26941 Knuckle Seal Remover
-
J 23907 Slide Hammer
1. Install the mount differential carrier with the J 37769
2. Place the differential carrier and the holding fixture into the J 3289-20
3. Inscribe alignment marks on the differential side bearing caps to ensure proper assembly.
4. Remove the two bolts (1) and the side bearing lock plates (2) from the differential carrier.