Tracker 4WD L4-1.6L VIN 6 (1998)
7. Install the J21777-101 in the side bearing bores with the J23597-1 through both of the J21777-101.
8. Rotate the J 21777-102 until both gage levels are parallel with the J 21777- 10 1.
9. Install the dial indicator spring loaded plunger extension through the J23597-1 and position over the 97 mm level of the J 21777-102.
10. Install the J 8001 to the J 23597-1 and position the J 8001 plunger over the spring loaded plunger extension and slightly load the J 8001.
11. Rotate the J 8001 adjustable face so that the needle indicates 0.
12. Slowly rotate the J 23597-1 back and forth so that the spring loaded plunger extension sweeps back and forth across the J 21777-102 while
observing the J 8001.
13. Stop the J 23597-1 at the J 8001 greatest point of deflection.
14. Without disturbing the J 8001 needle setting, rotate the J 8001 adjustable face so that the needle indicates 0.
15. Slowly rotate the J 23597-1 until the spring loaded plunger extension is no longer making contact with the J 21777-102
16. Record the deflection reading on the J 8001.
IMPORTANT: This reading indicates the selective shim required for the correct pinion depth. Refer to the Spacer and Shim Specifications
Pinion Depth Selective Shims Table for the appropriate shim size.
17. Remove the J 8001 and the spring loaded plunger extension from the J 23597-1
18. Remove the J23597-1 and the two J 21777-101 from the differential carrier.
19. Remove the J 21777-102, the J 3289-21,the J 21777-43 and the J 21777-42 from the differential carrier.
20. Remove the inner pinion bearings from the differential carrier.
21. Remove the outer pinion bearing from the differential carrier.
Differential Case Assembly Assemble
INSTALLATION PROCEDURE
^
Tools Required
-
J 3289-20 Holding Fixture Base
-
J 3289-21 Holding Fixture
-
J 37769 Differential Holding Fixture Adapters
-
J 8614-01 Flange Holder
-
J 24433 Side Bearing Installer
-
J 8107-4 Differential Side Bearing Remover Plug
-
J 8092 Driver Handle
