Tracker 4WD L4-1.6L VIN 6 (1998)
3. Install the pinion shaft roll pin into the differential case (1) and through the pinion shaft (3). The roll pin end should be even with the differential
case surface.
4. Install the ring gear (1) to the differential case. Secure with ten bolts.
^
Tighten the ring gear bolts to 85 Nm (63 ft. lbs.).
IMPORTANT: After correct end play has been obtained, remove the ring gear bolts (1) and apply GM P/N 12345493, or equivalent, to the
threaded portion of each ring gear bolt and install into the differential case.
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Install the side bearing (1) on the left side of the differential case (2) assembly using the J 37758 with the J 8092. Place the differential case
assembly on a hydraulic press.