Tracker 4WD L4-1.6L VIN 6 (1998)
^
Tighten the rear trailing rod through bolts and nuts to 90 Nm (66 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
7. Install two nuts and washers (one on each side) to lower the rear shock absorber through bolts (3) at the rear axle housing.
^
Tighten the lower rear shock absorber through bolt and nuts to 85 Nm (63 ft. lbs.).
8. Install the rear axle breather hose (2) the rear axle housing (3). Secure the breather hose with one clamp (1).
9. Install the brake fluid pipes (2) to the rear axle housing.
10. Install five brake pipe clamps (1) to the rear axle housing.
11. Secure the brake fluid pipes and the clamps with five screws.