Tracker 4WD L4-1.6L VIN 6 (1998)
4. Place the outer pinion bearing into the differential carrier and install a J 21777-102, a J 23597-12, a J 21777-43 and a J 21777-42.
5. Hold the J 21777-43 stationary and tighten the jam nut.
^
Tighten the jam nut to 2 Nm (18 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
6. Rotate the J 21777-102 25 revolutions to ensure the pinion bearings are fully seated.
7. Re-tighten the jam nut. Tighten
^
Tighten the jam nut to 2 Nm (18 inch lbs.).
8. Install the J 21777-101 in the side bearing bores with J 23597-1 through both side bearing discs.
9. Rotate the J 21777-102 until both gauging levels are parallel with the J 21777-101.