Tracker 4WD L4-1.6L VIN 6 (1998)
Transmission Mount: Service and Repair
REMOVAL PROCEDURE
1. Raise and support the vehicle.
2. Support the transmission with a suitable hydraulic jack.
3. Remove one bolt and the ground wire from the speedometer driven gear case.
4. Temporarily install the speedometer driven gear case retaining bolt.
5. Remove the two bolts from the rear transmission mount (1).
6. Remove the four bolts and the rear transmission crossmember from the vehicle.
7. Remove one bolt and the rear transmission mount (2) from the extension case (1).
INSTALLATION PROCEDURE