Tracker 4WD L4-1.6L VIN 6 (1998)
8. Disconnect the four-wheel drive switch electrical connector (1) from the four-wheel drive switch (2).
9. Remove the four-wheel drive switch from the transfer case by turning counterclockwise.
10. Inspect the four-wheel drive switch O-ring for cuts or other damage. Replace as necessary.
INSTALLATION PROCEDURE
1. Install the four-wheel drive switch into the transfer case by turning clockwise.
^
Tighten the four-wheel drive switch to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Connect the four-wheel drive switch electrical connector (1) to the four-wheel drive switch (2).
3. Install the gearshift control lever into the gearshift lever case, pushing down on the shift control lever pivot and turning clockwise 90 degrees (1/4
turn) and releasing.
4. Install the gearshift lever case boot to the gearshift lever case. Secure the boot (3) with one clamp.
5. Install the gearshift control lever boot (1) and the boot cover onto the gearshift control lever (2). Secure the boot and the cover with eight screws.
