Tracker 4WD L4-1.6L VIN 6 (1998)
7. Remove the front output shaft oil seal (1) from the transfer case using J 26941 and J 23907 (if equipped).
8. Remove the front output shaft plug from the transfer case (if equipped).
INSTALLATION PROCEDURE
^
Tools Required
-
J 37751 Oil Seal Installer
-
J 36850 Transjel Transmission Assembly Lubricant
1. Install the new front output shaft oil seal into the transfer case (1) using J 37751 (if equipped).
2. Install the new front output shaft plug into the transfer case using J 37751.
3. Apply J 36850 to the new front output shaft oil seal lip (if equipped).
4. Install the front propeller shaft into the vehicle aligning the reference marks made during the removal. Secure the shaft with four bolts and four
nuts (if equipped).
^
Tighten the front propeller shaft bolts and nuts to 50 Nm (37 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Apply GM P/N 12346004, or the equivalent, to the threaded portion of the transfer case drain plug.
6. Install the transfer case drain plug into the transfer case.
^
Tighten the transfer case drain plug to 28 Nm (21 ft. lbs.).
7. Add approximately 1.7 liters (1.8 qts.) of 75W-90 GL4 lubricant, or the equivalent, into the transfer case oil level/filler plug hole. The oil level
should be even with the bottom of the oil level/filler plug hole.
8. Apply GM P/N 12346004, or the equivalent, to the threaded portion of the transfer case oil level/filler plug.
9. Install the transfer case oil level/filler plug into the transfer case.
^
Tighten the transfer case oil level/filler plug to 28 Nm (21 ft. lbs.).
10. Lower the vehicle.
^
Tools Required
-
J 26941 Needle Bearing Puller
-
J 23907 Slide Hammer
