Tracker 4WD L4-1.6L VIN 6 (1998)
Four Wheel Drive Selector Switch: Service and Repair
Selector Switch Replacement (4WD Low Switch)
REMOVAL PROCEDURE
1. Disconnect the negative (-) battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting Points.
3. Disconnect the four-wheel drive low switch electrical connector from four-wheel drive low switch.
4. Remove the four-wheel drive low switch (4) from the transfer case by turning counterclockwise.
5. Inspect the four-wheel drive switch O-ring for cuts or other damage. Replace as necessary.
INSTALLATION PROCEDURE
1. Install the four-wheel drive low switch into the transfer case by turning clockwise.
^
Tighten the four-wheel drive low switch to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Connect the four-wheel drive low switch electrical connector (3) to the four-wheel drive low switch (4).
3. Lower the vehicle.
4. Connect the negative (-) battery cable.