Tracker 4WD L4-1.6L VIN 6 (1998)
2. Secure the transfer case rear mount with one bolt.
^
Tighten the transfer case rear mount bolt to 50 Nm (37 ft. lbs.)
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the transfer case crossmember (1) to the undercarriage.
4. Secure the transfer case crossmember with six bolts.
^
Tighten the transfer case crossmember bolts to 50 Nm (37 ft. lbs.).
5. Install the three torque stopper mounting bolts to the transfer case crossmember.
^
Tighten the torque stopper mounting bolts to 50 Nm (37 ft. lbs.).
6. Install the transfer case skid plate to the transfer case crossmember.
7. Secure the transfer case skid plate with two bolts.
^
Tighten the transfer case skid plate bolts to 54 Nm (40 ft. lbs.).
8. Remove the hydraulic transmission jack.
9. Lower the vehicle.
