Tracker 4WD L4-2.0L VIN C (1999)
7. Suspend the caliper and the caliper bracket (1) with a wire (2) in order to prevent damage to the brake hose.
8. Inspect the brake rotor for thickness variation.
9. Inspect the brake rotor for lateral runout.
10. Inspect the brake rotor surface.
11. Remove the brake rotor from the wheel hub. If necessary, install two 8 mm bolts into the rotor. Tighten the bolts in order to force the rotor off of
the wheel hub.
INSTALLATION PROCEDURE
1. Install the brake rotor to the hub.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Place the caliper (1) and the caliper bracket (2) into position. Secure the caliper and the caliper bracket with the 2 caliper bracket mounting bolts.
^
Tighten the bolts to 85 Nm (61.5 ft. lbs.).
3. Install the tire and wheel assembly.
4. Lower the vehicle.
5. Fill the master cylinder reservoir.
6. Start the engine.
7. Press the brake pedal several times in order to position the caliper piston.