Tracker 4WD L4-2.0L VIN C (1999)
Intake Manifold: Service and Repair
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Relieve the fuel pressure. Refer to Fuel Pressure Release Procedure in Powertrain Management.
3. Drain the engine coolant. Refer to Draining and Filling Cooling System in Cooling System.
4. Remove the air cleaner hose.
5. Remove the 1 bolt and the accelerator cable bracket (2) from the intake manifold.
6. Remove the cables from the throttle body bellcrank.
7. Disconnect the following electrical connectors:
^
The fuel injector harness (3)
^
The Manifold Absolute Pressure (MAP) sensor (11)
^
The Throttle Position Sensor (TPS) (8)
^
The Idle Air Control (IAC) valve (6)
^
The EVAP canister purge valve (7)
^
The Exhaust Gas Recirculation (EGR) valve (1)
8. Remove the bolt and the ground wires from the intake manifold (10).
9. Remove the EVAP canister purge hose from the intake manifold.
