Tracker 4WD L4-2.0L VIN C (1999)
9. Remove the 4 bolts (2) and the water pump from the vehicle.
10. Remove the dowel pins from the engine block.
Installation Procedure
1. Install the dowel pins to the water pump.
2. Install a new O-ring to the water pump and to the heater outlet line.
Important: Use new bolts when installing the water pump. Failure to do so may result in leakage.
3. Install the water pump using 4 new bolts (2).
Tighten the bolts to 27 Nm (20 ft. lbs.).
4. Install the A/C compressor to its mounting bracket.
Tighten the 3 bolts to 23 Nm (17 ft. lbs.).
5. Install the 1 bolt and the heater outlet line to the rear of the water pump housing.
Tighten the bolts to 15 Nm (11 ft. lbs.).
6. Install the 4 bolts and the water pump pulley to the water pump.
Tighten the bolts to 23 Nm (17 ft. lbs.).
7. Install the 3 bolts and the thermostat housing to the water pump housing.
