Tracker 4WD L4-2.0L VIN C (1999)
1. Route the temperature cable (4) into the instrument panel as previously noted.
2. Hook the, end of the cable into the hole in the lever arm.
3. Slide the sheath back on the cable.
4. Line up the sheath with the sheath retainer.
5. Slide the sheath into its retainer until it snaps into place.
6. Install the heater control unit.
7. Install the temperature control cable (1) onto the pin of the temperature door and install the cable to the clip at the heater case.
8. Adjust the cable as necessary. Refer to Temperature Control Cable Adjustment.
Mode Control Cable Replacement
REMOVAL PROCEDURE
1. Remove the mode control cable from the clip (2) at the heater case. Unhook the cable from the mode door pin.
