Tracker 4WD L4-2.0L VIN C (1999)
3. Remove the fresh/recirc control cable (1) from the clip at the blower case. Unhook the cable from the fresh/recirc door pin.
4. Remove the heater control assembly from the Instrument Panel (IP) in order to gain access to the cable. Do not remove the heater control assembly
from the vehicle.
5. Gently pry the fresh/recirc control cable (3) sheath from the heater control unit. Unhook the cable from the lever arm.
IMPORTANT: Note the routing position of the cable in order to facilitate installation.
6. Remove the fresh/recirc control cable from the Instrument Panel.
INSTALLATION PROCEDURE
1. Route the fresh/recirc cable (3) into the Instrument Panel as previously noted.
2. Hook the end of the cable into the hole in the lever arm.
3. Slide the sheath back on the cable.
4. Line up the sheath with the sheath retainer.