Tracker 4WD L4-2.0L VIN C (1999)
12. Install the fresh/recirc control cable (1) onto the pin of the fresh/recirc door and install the cable to the clip at the heater case.
13. Close the IP compartment.
14. Install the temperature control cable (1) at the heater case.
15. Install the mode control cable (3) at the heater case.
16. Connect the defroster switch (1), if equipped.
17. Install the defroster switch, if removed. Secure with the 2 screws.
18. Adjust the control cables as necessary. Refer to the following:
^
Temperature Control Cable Adjustment
^
Mode Control Cable Adjustment
^
Vent Control Cable Adjustment
