Tracker 4WD L4-2.0L VIN C (1999)
Heater Core: Service and Repair
Heater Case/Cover Replacement
Removal Procedure
1. Drain the engine cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
2. Remove the Instrument Panel (IP) carrier.
3. Remove the heater hoses and clamps from the heater core.
4. Disconnect the electrical connector from the A/C compressor control module (2), if equipped.
5. Remove the A/C compressor control module (2), if equipped.
6. Remove the 2 nuts and 6 screws (3) from the air box.
7. Remove the air box from the vehicle. If equipped with A/C, remove the evaporator.
8. If necessary to remove the blower case, perform the following:
8.1. Disconnect the blower motor electrical connector.
8.2. Disconnect the blower motor resistor electrical connector.
8.3. Remove the fresh/recirc control cable from the blower case.