Tracker 4WD L4-2.0L VIN C (1999)
2. Secure the hose to the reservoir (3) with the hose clamp.
3. Install the inlet pipe to the power steering gear outlet hose.
4. Secure the pipe to the hose with the hose clamp.
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Secure the 3 power steering fluid reservoir inlet pipe clamps with the 3 bolts.
-
Tighten the bolts to 11 Nm (8.0 ft. lbs.).
NOTICE: Refer to Using Proper Power Steering Fluid When Adding in Service Precautions.
6. Add power steering fluid to the reservoir. Refer to Checking and Adding Power Steering Fluid.
NOTICE: Refer to Air In The Steering System in Service Precautions.
7. Bleed the power steering system. Refer to Bleeding Power Steering System.
