Tracker 4WD L4-2.0L VIN C (1999)
PROM - Programmable Read Only Memory: Customer Interest
PCM - Rough/Unstable Idle During Warm Up
BULLETIN NUMBER:
00-06-04-013
SECTION:
06 - Engine/Propulsion System
DATE:
March 2000
TECHNICAL
SUBJECT:
Rough/Unstable Idle During Engine Warm Up (Reprogram PCM)
MODELS:
1999-2000 Chevrolet Tracker with Manual Transmission
CONDITION
Some customers may comment that their vehicle may run rough when idling with the clutch depressed after a cold start-up, until the coolant temperature
reaches normal operating temperature.
CAUSE
The actual idle speed may drop below the desired idle speed.
CORRECTION
Reprogram the PCM using the TIS 2000 software with CD # 20/21 or later for 1999. Refer to Bulletin Number 99-06-04-060 for the PASS THRU
programming procedure, which is also reprinted below.
For model year 1999 and 2000, U.S. and Canadian dealers will have the capability of reprogramming the Powertrain Control Module (PCM) used in the
Tracker vehicles. When performing this procedure, you will need a Tech 2 scan tool and a Techline terminal. The Techline terminal must be a minimum
of a T7.
Important: Refer to TIS 2000 operation in the Tech 2 User's Guide for set-up and if operational difficulties occur.
1. Open the TIS 2000 software application from the Techline terminal.
2. From the Application Selection screen, select SERVICE PROGRAMMING SYSTEM. The SELECT DIAGNOSTIC TOOL AND
PROGRAMMING PROCESS screen should appear.
3. Select PASS THRU.
4. Select REPROGRAM ECU or REPLACE AND REPROGRAM ECU.
5. Select either VEHICLE or OFF BOARD PROGRAMMING ADAPTER (OBPA).
6. If your selections are correct, press the NEXT key.
7. At the CONNECT DIAGNOSTIC TOOL/DETERMINE VEHICLE screen, enter the correct information until the NEXT key is highlighted then
click NEXT.
8. Turn the ignition ON.
9. Follow the directions on the CONNECT DIAGNOSTIC TOOL screen, then click NEXT. The VALIDATE VEHICLE IDENTIFICATION
NUMBER screen should appear.
10. The correct Vehicle Identification Number (VIN) may appear. If not, highlight the square and correct the VIN.
11. Select NEXT and an option screen will appear. Ensure that all the entered information is correct. If not, enter the correct information.
12. The CALIBRATION SELECTION screen should appear. Verify the current calibrations with the selected calibrations.
13. A summary screen will appear. If correct, enter NEXT.
