Tracker 4WD L4-2.0L VIN C (1999)
Verify your selection on the Summary screen.
I. Select Next.
6. Close the application and return to the TIS application Selection screen after the download is complete.
7. Turn OFF the Tech 2.
8. Disconnect the Tech 2 from the terminal.
9. Transfer the data from the Tech 2 to the control module using the following procedure:
A. Connect the Tech 2 to the vehicle DLC, with the engine and the Tech 2 OFF.
B. Turn ON the Tech 2.
C. Press Enter at the Title screen.
D. Turn ON the ignition, with the engine OFF.
E. Select Service Programming System.
F. Select the Program ECU function on the Tech 2.
G. Verify the VIN and calibration numbers, select Continue.
H. Follow the on-screen instructions and select Continue.
I.
Select continue and exit the program after the Tech 2 displays Programming was Successful.
10. Turn OFF the ignition.
11. Turn OFF the Tech 2.
12. Disconnect the Tech 2 from the vehicle.
Programming Verification
1. Turn OFF the ignition for 30 seconds.
2. Attempt to start the engine.
3. Repeat the Service Programming procedure if the engine does not start or has an engine performance concern.
Pass-Thru Programming
Pass-Thru programming allows the scan tool to remain connected to the terminal and to the vehicle throughout the programming process. The vehicle
must be in close proximity to the terminal while using Pass-Thru.
Performing the Pass-Thru Procedure
Important: The TIS supports service programming with the Tech 2 scan tool only.
Launch the TIS application at the terminal.
1. Select the Service Programming System.
2. Highlight the following information on the Select Diagnostic Tool and Programming Process screen:
^ Select Diagnostic Tool--Select Pass-Thru
