Tracker 4WD L4-2.0L VIN C (1999)
Manifold Absolute Pressure (MAP) Sensor: Service and Repair
MAP Sensor Replacement
REMOVAL PROCEDURE
1. Disconnect the MAP sensor electrical connector (4) from the MAP sensor (1).
2. Remove the two MAP sensor attaching bolts (1).
3. Remove the MAP sensor (2) from the intake plenum.
INSTALLATION PROCEDURE
1. Lubricate the seal on the MAP sensor vacuum port with clean engine oil.
2. Install the MAP sensor (2) into the intake plenum.
NOTE: Refer to Fastener Notice in Cautions and Notices.
