Tracker 4WD L4-2.0L VIN C (1999)
Four Wheel Drive Selector Switch: Service and Repair
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative (-) battery cable.
2. Remove the shift lever (1). Refer to Shift Lever Replacement - On Vehicle.
3. Disconnect the four-wheel drive switch electrical connector (1) from the four-wheel drive switch (2).
4. Remove the four-wheel drive switch from the transfer case by turning counterclockwise.
5. Inspect the four-wheel drive switch O-ring for cuts or other damage. Replace as necessary.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the four-wheel drive switch into the transfer case by turning clockwise.
^
Tighten the four-wheel drive switch to 20 Nm (15 ft. lbs.).