Tracker 4WD L4-2.0L VIN C (1999)
36. Stretch the passenger deployment harness to full length.
37. Place a power source, 12 V minimum/2 A minimum (i.e., a vehicle battery) near the shorted end of the harness.
38. Separate the two ends of the passenger frontal deployment harness wires.
39. Connect the passenger frontal deployment harness wires to the power source in order to deploy the Inflatable Restraint IP module.
40. Disconnect the passenger frontal deployment harness wires from the power source.
41. Twist together one end of each wire on the driver frontal deployment harness in order to short the wires.
42. Twist together one end of each wire on the passenger frontal deployment harness in order to short the wires.
43. Remove the drop cloth from the vehicle.
44. Disconnect both harnesses from the vehicle.
45. Discard the harnesses.
46. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
47. If one or both of the modules did not deploy, perform the following steps:
47.1. Remove the undeployed module(s) from the vehicle. Refer to the following procedures:
-
Inflatable Restraint Steering Wheel Module Replacement
-
Inflatable Restraint Instrument Panel Module Replacement
47.2. Temporarily store the module(s).
47.3. Call the Technical Assistance Group for further assistance.
Side Air Bags
Deploy the inflator modules inside of the vehicle when destroying the vehicle or when salvaging the vehicle for parts. This includes but is not limited to
the following situations:
^
The vehicle has completed its useful life.
^
Irreparable damage occurs to the vehicle in a non-deployment type accident.
^
Irreparable damage occurs to the vehicle during a theft.
^
The vehicle is being salvaged for parts to be used on a vehicle with a different VIN as opposed to rebuilding as the same VIN.
Caution: When you are deploying an Inflator Module for disposal, perform the deployment procedures in the order listed. Failure to follow the
procedures in the order listed may result in personal injury.
