Tracker 4WD L4-2.0L VIN C (1999)
10. Disconnect the following connectors from the rear of the junction block (5):
^
Junction block connector C1 (4)
^
Junction block connector C2 (3)
^
Junction block connector C3 (2)
11. Remove the junction block (5) from the vehicle.
12. Remove the turn/hazard flasher (1) from the junction block (5), if necessary.
13. Remove the fuses and relays from the front of the junction block (5), as necessary.
INSTALLATION PROCEDURE
1. Install any fuses and relays that were removed from the front of the junction block (5)
2. Install the turn/hazard flasher (1) to the junction block (5), if removed.
