Tracker 4WD L4-2.0L VIN C (1999)
Steering Shaft: Service and Repair
Steering Wheel and Column - Standard
Steering Shaft Coupling Replacement
REMOVAL PROCEDURE
1. Ensure the front tires and wheels are in the straight ahead position.
2. Rotate the steering wheel to the left in order to position the opening in the steering shaft coupling (2) in the vertical position.
3. Using paint, place match marks (3) on the steering column shaft (1) and the lower steering shaft in order to mark the location of the opening in the
steering shaft coupling (2).
4. Remove the key from the ignition switch.
NOTICE: The steering column must be in the LOCK position before disconnecting the following components:
-
The steering column
-
The steering shaft coupling
-
The intermediate shaft
-
The lower steering shaft
After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment
of some components during installation and result in possible damage to the SIR coil.
5. Turn the steering wheel to the left in order to lock the steering column and allow access to the steering shaft coupling bolts (4,5).
