Tracker 4WD L4-2.0L VIN C (1999)
2. Install the shock absorber lower bolt (2). The bolt should be toward the center of the body, and the nut should be towards the outside of the body.
Do NOT tighten the nut.
3. Install the wheel speed sensor clamp (if equipped) and install the E-ring.
4. Connect the breather hose to the axle housing.
5. Connect the park brake cable hanger (1) to the chassis frame (2) and clamp the hanger to the cross member.
6. Remove the floor jack from the axle housing.
7. Lower the vehicle. Verify that the weight of the vehicle is on the tires and wheels.
8. Install a new shock absorber nut.
-
Tighten the shock absorber lower nut to 85 Nm (61.5 ft. lbs.).
