Tracker 4WD L4-2.0L VIN C (1999)
Suspension Strut / Shock Absorber: Service and Repair
Rear Shock Absorber
REMOVAL PROCEDURE
1. Raise and support the vehicle.
2. Support the rear axle housing (1) by using a floor jack.
3. Remove the shock absorber nut (1).
4. Remove the lower mounting nut (8) and the lower mounting bolt (7).
5. Remove the following components:
-
The shock absorber (6)
-
The upper support (2)
-
The upper bushing (3)
-
The lower bushing (4)
-
The lower support (5)
INSTALLATION PROCEDURE
IMPORTANT: Use a new shock absorber nut (1) when installing the shock absorber.
IMPORTANT: DO NOT tighten the nuts and bolts completely. The weight of the vehicle must be on the wheels and tires before tightening the nuts
and bolts.