Tracker 4WD L4-2.0L VIN C (1999)
9. Remove the TCC solenoid (1) from the lower valve body.
10. Inspect the TCC solenoid pipe O-ring (2) for cuts and other damage. Replace the O-ring as necessary.
11. For a complete schematic of the TCC system, refer to Automatic Transmission Controls Schematics.
Installation Procedure
1. Install the new TCC solenoid gasket and TCC Solenoid (1) onto the lower valve body.
Notice: Refer to Fastener Notice in Service Precautions.
2. Secure the TCC solenoid onto the lower valve body with the 2 bolts.
^
Tighten the TCC solenoid bolts to 5 Nm (44 inch lbs.).
3. Install the electrical connector to the TCC solenoid.
4. Apply a thin coat of automatic transmission fluid to the fluid pipe O-rings.
5. Install the fluid pipes in the following order 8, 4 and 7.
6. Install the valve body. Refer to Valve Body and Accumulator Pistons Removal.
7. Install the drain pan. Refer to Automatic Transmission Fluid/Filter Changing.
8. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front.
9. Lower the vehicle.
10. Connect the negative (-) battery cable.
11. Refill the transmission as necessary using the following procedure.
