Tracker 4WD L4-2.0L VIN C (1999)
11.1.
Place the vehicle on a level surface
11.2.
Remove the fluid level indicator
11.3.
Add approximately 1.5 liters (1.6 qts) or Dexron-III automatic transmission fluid GM P/N 12346143, or the equivalent, into the fluid
filler tube.
11.4.
Install the fluid level indicator into the fluid filler tube.
11.5.
Apply the parking brake and block the vehicle wheels.
11.6.
With the selector lever in the PARK position, start the engine. Do not race the engine.
11.7.
Run the engine at idle and move the selector lever through each range and return to the PARK position.
11.8.
With the engine running at idle, remove the fluid level indicator from the filler tube and wipe the indicator off.
11.9.
Reinsert the fluid level indicator into the filler tube making sure it is seated in its original position.
11.10.
Remove the indicator and check the fluid level. The level should be between the FULL HOT and LOW HOT marks. If the level is below
the LOW HOT mark, add fluid to bring the level to the FULL HOT mark. Bringing the fluid level from the LOW HOT mark to the FULL
HOT mark requires 0.3 liters (0.3 qts) of fluid. Use Dexron-III(r) automatic transmission fluid GM P/N 12346143, or the equivalent.
11.11.
Conduct a road test and check the transmission level. Refer to Transmission Fluid Checking Procedure.
