Tracker 4WD L4-2.0L VIN C (1999)
9. Remove the 2 snap rings (2) from the propeller shaft yoke.
10. Using an 18 mm (2) socket in conjunction with a 24 mm (3) socket and a soft-jaw vise, place the propeller shaft yoke into the soft-jaw vise with
the 18 mm socket acting as a driver and the 24 mm socket acting as a hollow support. Tighten the vise until the bearing cap inside of the 24 mm
socket has been exposed approximately 3 - 4 mm (0.12 - 0.16 inch).
11. Remove the bearing cap (2) from the propeller shaft yoke by placing the exposed portion of the bearing cap into a soft-jaw vise. Tap upwards on
the propeller shaft yoke with a hammer until the bearing cap is free of the propeller shaft yoke.
