Tracker 4WD L4-2.0L VIN C (1999)
18. Remove the drive axle shaft oil seal (1) and set assembly aside.
19. Make a reference mark (2) on the following components in order to ensure correct installation.
^
The inner drive axle flange (1)
^
The differential side joint flange (3) of the drive axle shaft
20. Remove the following components from the inner axle shaft flange:
^
The 3 bolts
^
The 3 nuts
^
The differential joint flange of the drive axle shaft
Installation Procedure
1. Install the drive axle shaft boot band.
2. Install the differential side joint flange of drive axle shaft to the inner axle shaft flange. Be sure to align the reference marks (2) on the inner axle
shaft flange (1) and the differential side joint flange (3) of the drive axle shaft.
Notice: Refer to Fastener Notice in Service Precautions.
3. Secure the 3 bolts and the 3 nuts.
