Tracker 4WD L4-2.0L VIN C (1999)
29. Install the front skid plate to the vehicle (if the vehicle is equipped) and secure with four bolts.
^
Tighten the front skid plate bolts to 54 Nm (40 ft. lbs.).
30. Lower the vehicle.
Right Side
RIGHT FRONT AXLE SHAFT
Removal Procedure
1. Raise and Support the vehicle. Refer to Vehicle Lifting.
2. Remove the following components (if the vehicle is equipped):
^
The 4 skid plate bolts
^
The front skid plate
3. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
4. Remove the 6 bolts (2) and the flange (1).
5. Remove the drive axle shaft snap ring (1)
6. Remove the drive axle shaft spindle washer (1) from the drive axle shaft.
7. Slowly lower the hydraulic jack in order to relieve the pressure in the coil spring.
8. Remove the drive axle shaft thrust washer.
