Tracker 4WD L4-2.0L VIN C (1999)
Shifter M/T: Service and Repair
Gearshift Lever Case Replacement
1. Remove the gearshift control lever from the gearshift lever case. Refer to Gearshift Control Lever Replacement
2. Remove 4 bolts from the fan shroud at the radiator.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Place a drain pan or suitable container underneath the transmission.
5. Remove the transmission oil level/filler plug (2) from the transmission.
6. Remove the transmission drain plug (3) from the transmission and drain the transmission oil.
7. Place index marks on the propeller shaft pinion flange yoke and the differential pinion flange to ensure correct installation.
8. Remove the following items from the vehicle:
^
4 bolts
^
4 nuts
^
The rear propeller shaft
9. Remove the VSS bolt and disconnect the VSS.
10. Remove the following items from the driven speedometer gear case.
^
1 bolt (2)
^
The ground wire (1)
