Tracker 4WD V6-2.5L VIN 4 (2001)
Replacement (Upper Right) .
Rear Side Door Trim Panel Replacement
Rear Side Door Trim Panel Replacement
Removal Procedure
1. Remove the rear side door inside handle (1). Refer to Rear Side Door Inside Handle Replacement (See: Rear Door Handle/Rear Door Interior
Handle/Service and Repair) .
2. Remove the screw which secures the rear side door pull handle (3).
3. Use a cloth in order to pull off the snap ring which secures the rear side door window regulator handle (1), if equipped.
4. Remove the window regulator handle (1), if equipped.
5. Gently pry the rear side door trim panel (2) from the rear side door by disengaging the plastic retainers which secure the panel.
6. Position the door trim panel (2) away from the door in order to gain access to the rear side window switch electrical connector, if equipped.
7. Disconnect the window switch electrical connector, if equipped.
8. Remove the door trim panel (2) from the vehicle.
9. Remove the rear side window switch from the door trim panel (2) by releasing the 4 plastic retaining tabs, as needed.
Installation Procedure