Tracker 4WD V6-2.5L VIN 4 (2001)
21. Apply a second coat of glass prep (clear #1) to the same area of the glass.
22. Wipe the glass primed area immediately with a clean lint free cloth.
23. Shake the glass primer (black #2) for at least 1 minute.
24. Use a new dauber in order to apply the glass primer (black #2) to the same areas that the glass prep (clear #1) was applied.
The glass primer (black #2) is good up to 8 hours after applying it to the glass. The primed surface of the glass must be kept clean.
25. Allow the primer to dry for approximately 10 minutes.
26. If using the short method, cut the tip of the applicator nozzle in order to provide an bead approximately 6.0 mm (0.25 in).
27. If using the extended method, cut the applicator nozzle in order to provide a bead of approximately 12.7 mm (0.5 in) wide and 12.7 mm (0.5 in)
high.
28. Use a cartridge-type caulking gun to apply a smooth, continuous bead of urethane adhesive.
29. When using the short method, apply the urethane adhesive to the existing bead of urethane adhesive on the body.
30. When using the extended method, use the edge of the rear door window or the inside edge of the reveal molding as a guide for the nozzle in order