Tracker 4WD V6-2.5L VIN 4 (2001)
Tighten the front seat belt guide loop anchor bolt to 35 N.m (25 lb ft).
3. Install the front seat belt guide loop cover (1).
4. Install the front (2) and rear (4) side door opening frame garnish moldings to the pinch weld flange (3) on both sides of the upper center pillar trim
(1).
Foot Rest Replacement
Foot Rest Replacement
Removal Procedure
1. Remove the left front foot rest cover (2) in order to gain access to the front floor foot rest mounting bolts (3).
2. Remove the following components from the vehicle:
1. The 2 mounting bolts (3)
2. The front floor foot rest (1)
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the front floor foot rest (1) to the vehicle. Secure the foot rest with the 2 mounting bolts (3).