Tracker 4WD V6-2.5L VIN 4 (2001)
5. Remove the following components from each side of the seat back cushion (1):
1. The plastic retainer from the lower section
2. The screw and rear seat back cushion bumper
3. The 2 screws (3)
4. The rear seat recliner inside lower finish cover (2)
6. Release the J-retainer (1) which secures each side of the rear seat back cushion cover.
7. Remove the seat back cushion cover (1) from the rear seat back cushion pad and frame (3).
Installation Procedure
1. Install the rear seat back cushion cover (1) to the rear seat back cushion pad and frame (3). Ensure that the cover is fully secured to the pad at the
velcro strips (2).