Tracker 4WD V6-2.5L VIN 4 (2001)
5. Fit the piston boot (3) onto the caliper groove.
Important: Do not pull the piston out of the cylinder.
6. Pull on the piston in order to confirm that the boot is properly fitted in the caliper groove.
7. Push the piston into the caliper. Seat the piston in the caliper bore.
Important: Tighten the bleeder valve while bleeding the hydraulic brake system.
8. Install the bleeder valve. DO NOT tighten.
9. Install the caliper on the vehicle. Refer to Brake Caliper Replacement.
10. Install the tire and wheel assembly.
11. Lower the vehicle.
12. Bleed the brake system.