Tracker 4WD V6-2.5L VIN 4 (2001)
Valve Cover: Service and Repair
Camshaft Cover Replacement (Left)
Removal Procedure
1. Remove the throttle body and intake manifold.
2. Remove the ignition coil cover.
3. Disconnect the ignition coil couplers.
4. Remove the ignition coils.
5. Remove the 4 nuts (2) on the camshaft cover (1).
6. Remove the camshaft cover (1).
Installation Procedure
1. Clean the sealing surfaces on the camshaft cover and the cylinder head.
2. Apply GM P/N 12346240 or equivalent to the cylinder head at the points indicated (1).
3. Install the new camshaft cover gasket to the camshaft cover.
4. Install the new cylinder head side seals to the cylinder head.