Tracker 4WD V6-2.5L VIN 4 (2001)
Front Crankshaft Seal: Service and Repair
Removal Procedure
1. Remove engine crankshaft balancer.
Important: To protect the crankshaft from damage, wrap the tip of the screwdriver with tape.
2. Carefully pry out the crankshaft front oil seal using a screwdriver.
Installation Procedure
1. Lubricate the new crankshaft front oil seal with Chassis Grease GM P/N1051344 or equivalent.
Important: Tap the oil seal in until its surface is flush with the crankshaft front oil seal retainer edge.
2. Using a hammer and an appropriate driver, lightly tap the crankshaft front oil seal into place.
3. Install the crankshaft balancer.