Tracker 4WD V6-2.5L VIN 4 (2001)
3. Install the clutch pulley to the compressor. Secure with a snap ring (1) and a shim.
4. Install the pressure plate to the compressor drive shaft.
5. Adjust the clearance (2) between the clutch pulley (3) and the pressure plate (1).
Pressure Plate-to-Pulley Clearance
0.3-0.5 mm (0.012-0.020 in)
6. Replace the shim in order to obtain the proper clearance.
7. Install the pressure plate washer and a new nut to the compressor drive shaft.
Tighten
Tighten the pressure plate nut to 15 N.m (11 lb ft).
8. Install the compressor to the vehicle.