chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3606 > < Initial Inspection and Diagnostic Overview|Page 3604
Page 7
background image

Steps 16-20

The numbers below refer to the step numbers in the diagnostic table.
3. This step checks whether the scan tool can communicate with other control modules on the vehicle. If the scan tool can communicate with one of

the other modules then the DLC connector, the shared circuits, and the scan tool are OK.

5. The modules supply a low current (about 1.85 mA) voltage on the serial data circuit. The normal circuit low current will NOT illuminate a test

lamp. If the circuit is shorted to battery positive the higher current will illuminate the test lamp.

7. If the engine starts and runs, the main relay is OK.
8. This step checks whether the PCM is receiving ignition positive voltage from the IG fuse located in the Junction Block. The main relay will not

energize and the PCM can not provide serial data without ignition positive voltage from the IG fuse circuit.

9. This step checks whether the PCM is receiving ignition positive voltage from the main relay when the ignition is ON. The PCM can not provide

serial data without ignition positive voltage from the main relay.

10. The PCM can not provide serial data without the correct power and grounds.
14. The scan tool may be damaged by high current flow on the serial data circuit at DLC terminal 7. Check the scan tool for proper operation on a

known good vehicle that uses terminal 7 of the DLC for serial data communication.

Scan Tool Does Not Power Up

CIRCUIT DESCRIPTION

The Data Link Connector (DLC) provides operating power for the scan tool at terminal 16 (battery positive voltage) and at terminal 4 (ground). The
DLC provides the class 2 serial data signals at terminals 2, 5, and 7.The scan tool will power up with the ignition off. Many modules, however, will
not communicate unless the DIM detects that the ignition is on and sends the appropriate power mode message. The DLC also provides a path at
terminal 8 to the Remote Control Door Lock Receiver for purpose of programming the remote keyless entry key fob.

TEST DESCRIPTION

Steps 1-4

Initial Inspection and Diagnostic Overview|Page 3606 > < Initial Inspection and Diagnostic Overview|Page 3604