Tracker 4WD V6-2.5L VIN 4 (2001)
Tighten
Tighten HO2S sensor to 45 N.m (32 lb ft).
2. Lower the vehicle.
3. Connect the HO2S 2 electrical connector.
HO2S BANK 2 SENSOR 2
NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Service Precautions.
Removal Procedure
IMPORTANT: The HO2S may be difficult to remove at temperatures above 48°C (120°F). In order to prevent damage to any threads in the exhaust
manifold, allow the exhaust system to cool down before attempting to remove the HO2S.
CAUTION: Refer to Vehicle Lifting Caution in Service Precautions.
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the HO2S 2 electrical connector.
3. Remove the HO2S 2 (1) from the exhaust pipe below the catalytic converter (2).
Installation Procedure
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
IMPORTANT: The new HO2S 2 comes with an antiseize coating on the sensor threads. Take precautions in order to prevent the removal of any of
the antiseize coating prior to installation. If the sensor was removed and is being reinstalled, an antiseize compound must be applied to the threads
before installation.
1. Install HO2S 2 (1) into the exhaust pipe below the catalytic converter (1).
Tighten
Tighten HO2S sensor to 45 N.m (32 lb ft).