Tracker 4WD V6-2.5L VIN 4 (2001)
5. Disconnect the following electrical connectors:
^
The Throttle Position (TP) sensor (2)
^
The Mass Air Flow (MAF) sensor (1)
^
The idle air control (IAC) valve (3)
6. Disconnect the ground terminal (5) from the intake collector.
7. Remove the clamp bracket (4) from the intake collector.
8. Disconnect the following electrical connectors:
^
The Manifold Absolute Pressure (MAP) sensor
^
The Evaporative Emission (EVAP) canister purge valve (2)
^
The Exhaust Gas Recirculation (EGR) valve (7)
9. Disconnect the following hoses:
^
The positive crankcase ventilation (PCV) hose from the cylinder head cover (9)
^
The breather hose from the throttle body (6)
^
The EVAP canister purge valve hose (1)
^
The water hose (8)
^
The heater hoses (3 5)
10. Remove the EGR pipe (4).
11. Remove the throttle body assembly.
12. Remove the intake manifold collector.
13. Remove the two EGR valve retaining bolts.
14. Remove the EGR valve from the intake collector.
15. Clean the EGR valve gasket from the intake collector.
INSTALLATION PROCEDURE
1. Install the EGR valve with a new gasket to the intake collector.