Tracker 4WD V6-2.5L VIN 4 (2001)
14. Connect the inflator module (1) to the adapter (2) on the SIR deployment harness (3).
15. Clear the area of people.
IMPORTANT:
^
When deploying an inflator module the rapid expansion of gas involved with deploying an inflator module is very loud. Notify all the people in the
immediate area that an inflator module will be deployed.
^
When the inflator module deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of a deploying inflator
module.
16. Separate the two banana plugs on the SIR deployment harness.
17. Place a 12 V minimum/2 A minimum power source (i.e. vehicle battery) near the shorted end of the SIR deployment harness.
IMPORTANT: The inflator module will deploy when the SIR deployment harness wires contact the power source.
18. Connect the SIR deployment harness wires to the power source. Inflator module deployment will occur when contact is made.
19. Disconnect the SIR deployment harness from the power source.
20. If the inflator module did not deploy, disconnect the adapter and discontinue the procedure. Contact the Technical Assistance Group. Otherwise,
proceed to the following steps.