Tracker 4WD V6-2.5L VIN 4 (2001)
17. Route the deployment harness out of the driver side of the vehicle.
18. Disconnect the inflatable restraint IP module connector (1).
19. Cut the IP module harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
20. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
21. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used for the IP module
deployment harness.
22. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
23. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until the inflator module is ready to be deployed.