Tracker 4WD V6-2.5L VIN 4 (2001)
Shift Interlock Cable: Service and Repair
Shift Lock Control Cable Replacement
Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System.
Failure to follow the correct procedure could cause the following conditions:
^
Air bag deployment
^
Personal Injury
^
Unnecessary SIR system repairs
In order to avoid the above conditions, observe the following guidelines:
^
Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
^
If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system.
1. Disable the SIR system.
2. Remove the following from the floor:
^
The 4 screws (1,6,3,4)
^
The 2 plastic retaining clips (2,5)
^
The console box
3. Remove the following components from the steering column:
3.1.
The screws
3.2.
The steering column upper cover
3.3.
The steering column lower cover
4. Remove the bracket retaining screw (2) from the ignition switch.
5. Remove the interlock cable (1) from the ignition switch.
6. Remove the interlock cable nut.
7. Remove the interlock cable at the manual selector.
8. Remove the interlock cable (1) out from under the instrument panel.